Installation
System Requirements
Linux 24.04
Hardware
Minimum Requirement
CPU
8 Cores
RAM
32 GB
DISK
500 SSD
Auto Install
While setting up Story Protocol, you will be asked for your Moniker name and the port number you want to use. After entering this information, you can successfully set up the Story Protocol Devoloper Mainnet network.
bash <(wget -qO- https://raw.githubusercontent.com/CoinHuntersTR/props/refs/heads/main/AutoInstall/aeneid.sh)
Check Logs for story-geth and story
sudo journalctl -u story-geth -f -o cat
sudo journalctl -u story -f -o cat
Synchronization Check
To check if your synchronization is complete, you can enter the following command. When entering the command, don't forget to replace '<portnumber>' with the port number you provided during setup. If you receive a 'False' output, you can proceed with the next steps.
curl localhost:<portnumber>657/status | jq
Export Wallet
story validator export --export-evm-key
Get wallet key and import to Metamask wallet
sudo nano ~/.story/story/config/private_key.txt
Import the private key of your validator wallet into your MetaMask wallet. min delegate 1024 IP
Register validator
story validator create \
--stake 1024000000000000000000 \
--moniker "" \
--chain-id 1514 \
--private-key $(cat $HOME/.story/story/config/private_key.txt | grep "PRIVATE_KEY" | awk -F'=' '{print $2}') \
--commission-rate 800 \
--max-commission-rate 5000 \
--max-commission-change-rate 500 \
--unlocked=false
Last updated